Page 1 of 1
Lathe accessories
Posted: Fri 20 Jul , 2012 9:07 am
by Denford Admin
Found this while looking through some bits I had scanned previously. Posted it as Dazz has made his own and there seemed to be a lot of interest in it.
Edit by Andy B - the post by Dazz is
here
Re: Viceroy copy and taper attachment pdf
Posted: Fri 20 Jul , 2012 12:18 pm
by dazz
Hi
My taper attachment is a genuine Denford factory original.
I made skates to follow the straight edge. These skates are intended to optimise surface finish.
Re: Viceroy copy and taper attachment pdf
Posted: Fri 20 Jul , 2012 12:45 pm
by Denford Admin
Ah sorry
I thought you'd made one...must have been someone else
Taper turing & Copying attachment
Posted: Thu 21 Aug , 2014 15:55 pm
by Andy B
Here are some component drawings for the taper turning and copying attachment.
I'll add more as I find them.
Re: Lathe accessories
Posted: Fri 22 Aug , 2014 2:36 am
by rpwilson
Excellent!
Richard
Re: Lathe accessories
Posted: Mon 18 May , 2020 7:52 am
by Andy B
Collet Attachment drawings:
Assy - ML107
- ML107.PDF
- Collet Assy
- (53.09 KiB) Downloaded 851 times
Handwheel - ML107-1
Drawbar - ML107-4A
Please don't post comments in this thread - put them in the general threads section.
Re: Lathe accessories
Posted: Tue 09 Feb , 2021 11:20 am
by Andy B
Boring Table and Milling Attachments
ML118/1 Boring table
ML130/1 Swivel Plate Slide, Milling Attachment
ML130/2 Swivel Tenon Plate, Milling Attachment
ML130/3 Swivel Vice, Milling Attachment
ML130/4 Vertical Slide, Milling Attachment
ML130/5 Adjusting Screw, Milling Attchment
ML132 Universal Milling Attachment
ML132/1 - Boring Table, Universal Milling Attachment
ML132/3 - Packing Plate, Universal Milling Attachment
ML132/6 - Angle Plate, Universal Milling Attachment
Please don't post comments in this thread - put them in the general threads section.