Search found 15 matches

Interesting lathe on ebay at the moment.

Item no. 111257524912

Well my old chuck was getting old, and was no good for precision work and i didn't have another set of jaws for it either, so i bought a new chuck ,£200 later and i had a 160mm vertex chuck and backplate, i am very pleased with it, although the backplate didn't fit properly and required some ...

Hi
I am looking for a D1-3 160mm backplate, and was wondering if anyone had one for sale?
thanks

whats the best way of going about making one?

Hi
Can anybody tell me the correct thread size for my lathe? is it 1/2" x 10TPI right or left hand?
Thanks

Hi
Id just like to say that my lathe is functional again, thanks to petes gear cutting skills, he made a very professionally job of cutting the gear.
thanks

IT WORKED!
thanks

Thanks i will give this a try

The for/rev is not momentary it latches in and out(in for forward out for reverse) and the start and stop switches are momentary (look at the control box on my lathe) the big red one and smaller green above it, i know it can be done just don't know how.

So you are using only two buttons to switch between for/rev and on/off

i want to use 3 buttons two for on/off and one for for/rev

Hi
where are the start and stop push buttons in this circuit?
Thanks

Hi
So does all this wire through the For and Rev inputs? Do you have a more detailed circuit diagram? and could you recommend what Relays to use ?

Thanks

hi
i have got the forward and reverse switches working on my inverter, the thing i am not sure about is the wiring/inputs for momentary start and stop buttons on my inverter (that is the same instruction book i have)

I have kept all the switches contact blocks just removed the main contactors at ...

Hi
Think i might change the pulleys, i had thought of it but i didn't have much money then as i had just paid £300 for the lathe, and £200 for the inverter, what do you think i would get the lathe? (just curious) i thought it was a good buy at £300 and it was my first proper lathe and only being 16 ...

Hi,
I'm new to the forum, and thought i would write a quick post (or not so quick).

I recently bought the viceroy 280vs off chrisG for £300, since i bought the lathe i have fixed a few problems, and encountered a few and also converted the lathe to single phase using a inverter.

1. Screw ...