Search found 11 matches

Could someone help with a PNC3 maintanance manual as we are having problems with a datum switch but in the test mode we are not clear as to what is what, but we believe all is explained in the PNC3 maintanance manual, Thank you.

Alan, if possible could you contact me with referance to one of your service exchange power cards as we have made the changes you advised and now we have lost the voltage at F3 all together so it might be less painful for both of us to change the board instead.

You sound a very useful person to know any chance we could have direct contact details.

The model number of the one we think is a problem is 3T787, this seems to have 3 secondary coils.

Just leaving a note in the hope that some one out there may have some PNC3 Spares, we are looking for toroiodal transformers but would be interested in most parts.

We have an Easimill 3, we left the machine switched on overnight and when we came in the next morning the machine was dead.
We checked all the power supplies and they seem ok but when we checked the test points on the PCB in the PNC3 we found we have no 5V but we do have 12V, could anyone give any ...

Are you still holding spares for a PNC3, if so could you let us know, thanks.

Looking for information as to what tapes are used in the easimill 3 tape deck and are they still avaliable.

Thanks for your response but we have managed to purchase a display, again many thanks

Replying in the hope you might still have the display from your Easimill re-fit, would it be compatible with an Easimill 3.

We have recently purchased an easimill 3 second hand and the display lives no longer, so we are looking for advice on how to replace the display. We have noticed the video output on the back could anyone advise us if this could be utilised in any way through a PC.
Would also be interested in ...