VCutter angle?

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
Posts: 6
Joined: Sun 17 Feb , 2019 7:20 am
Hardware/Software: denford cnc router 2600 pro
QuickCam 2D Design VCarve
QuickCam Pro
QuickCam 4D
VR Milling V5
Location: Brisbane Aus

VCutter angle?

Post by markymac » Thu 24 Sep , 2020 17:11 pm

I've recently acquired some new tools for my router and was hoping someone could clarify what angle I should be using when setting up a VCutter.
TOOL SETUP.png (37.39 KiB) Viewed 366 times
On the packaging they use either an angle measured off the vertical or an angle describing the point (hopefully the pic I've attached will clarify what I'm struggling to describe)

any help would be greatly appreciated

CNC Guru
CNC Guru
Posts: 524
Joined: Tue 29 Apr , 2014 18:38 pm
Hardware/Software: Starturn 5 (sort of running, I will get this done!)
Lathe cam designer V1.11
Quickturn 2D Design
FANUC offline and online programs.
Microrouter Pro NS V5 (microstep)
VR2 and VR5
Boxford VMC260
Techsoft 2d Design tools V1 > V2
Fusion 360

Re: VCutter angle?

Post by TDIPower » Thu 24 Sep , 2020 21:30 pm

As far as i know its your drawing B


Post Reply