I just inherited 12 Denfords. All pretty much brand new, and I could use some help. Firstly can anyone tell me how to update my Micromill Integrator. I have the the @ 97 software and i would like to get it to a more 3dish view. All the mills are about 10 years old and they have allthe original software.
Any help would be appreciated.
Micromill Integrator
Moderators: Martin, Steve, Mr Magoo
-
paul_hodgson
- Posts: 1
- Joined: Thu 29 Mar , 2007 1:14 am
- Location: London, Ontario
Micromill Integrator
Paul Hodgson
Computer Engineering
Beal Secondary School
Computer Engineering
Beal Secondary School
-
Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
I'm guessing its the DOS software you have ?
I'm not sure what control was fitted to a Micro machine in 1997, but guess it would be a Smartstep ?
Can you take a look at this PDF
http://www.denfordata.com/projectimages ... _guide.pdf
It should answer your question, and confirm to us what control(s) you have.
I'm not sure what control was fitted to a Micro machine in 1997, but guess it would be a Smartstep ?
Can you take a look at this PDF
http://www.denfordata.com/projectimages ... _guide.pdf
It should answer your question, and confirm to us what control(s) you have.