Cyclone Fanuc 21i is not reading G32 and coolant

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Cyclone Fanuc 21i is not reading G32 and coolant

Post by bradders » Thu 29 Mar , 2007 8:47 am

I am trying to screw cut multi start threads, but having trouble with the Cyclone Fanuc 21i getting it to read G32, I am getting a error message "code not recognised"

also all 21i not reading coolant codes.

When reading Coolant on/off codes on both fanuc21i Mill & Lathe Controller hangs
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 29 Mar , 2007 10:27 am

Try G76 for threading (look in the Fanuc user manual for details)

The cyclone has a coolant selector switch for Manual or Automatic operation of the coolant - check that this is set to Auto in order for M08 / M13 / M14 to work.
Top
Post Reply

Return to “Software”