Prodesktop / Achiever

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Prodesktop / Achiever

Post by Benny » Thu 01 Mar , 2007 15:55 pm

Customer having problem with Achiever ---- isn’t showing anything in the window, it’s just blank. Tried 2 different CD’s to load the program. The cd did work on one computer, but not the others. It’s like something is blocking the graphics in the window. Could this have something to do with Internet Explorer settings blocking the content or something else? Please advise.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 01 Mar , 2007 18:09 pm

I think there have been problems in the past related to IE settings and possibly the macromedia flash was not installed.
Try lower the Security settings in IE right down, and install flash player - as it works on one machine it must be to do with the setup of IE and related software.
Top
Post Reply

Return to “Software”