A picture has been added. 
Is it possible to drip feed to this machine. We have just found this Starmill a few days ago and would like to get it moving. A manual would be useful A picture has been added.
A picture has been added.
Attachments:
- P1010004.JPG (55.12 KiB) Viewed 5939 times
Last edited by davisa on Tue 06 Feb , 2007 17:49 pm, edited 3 times in total.
CNC Guru
This is an NEE version of the Starmill (fitted with an SMCU controller)
It must be connected to a PC to enter and run CNC programs (you can not program the machine from the front panel, only jog it around)
Software and cable diagrams can be found here viewtopic.php?t=196 - use the "Starmill SMCU" software in the zip!
It must be connected to a PC to enter and run CNC programs (you can not program the machine from the front panel, only jog it around)
Software and cable diagrams can be found here viewtopic.php?t=196 - use the "Starmill SMCU" software in the zip!