MillCAM Designer TrueType font converter

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

MillCAM Designer TrueType font converter

Post by Denford Admin » Thu 25 Jan , 2007 17:57 pm

This utility convertor will convert any Windows True Type font into a font that can be used within Mill Cam Designer.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 25 Jan , 2007 17:58 pm

Download it here:
https://www.denfordata.com/downloads/usa ... fmcd16.zip

Its a 510Kb zip file
Top
Post Reply

Return to “Software”