VR Milling virtual machine billet is wrong size

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

VR Milling virtual machine billet is wrong size

Post by Denford Admin » Thu 25 Jan , 2007 16:35 pm

Q. When using a virtual CNC machine, the stock mounted on the machine is the wrong size or is mounted incorrectly.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 25 Jan , 2007 16:36 pm

1.) With the VR window active, click Setup > Default Billet Size.
2.) Change the X, Y, and Z billet size.
3.) You may also change the X and Y position.
4.) Click OK.
Top
Post Reply

Return to “VR Milling - All Versions”