1995 Triac Software (Advice needed!)

GingerNinja54 · Post by **GingerNinja54** » Thu 02 Sep , 2021 14:42 pm

Having purchased a 1995 Triac VMC, I need to source Control, CAM and perhaps even CAD software. (Unfortunately the college from which I purchased the VMC couldn’t provide this).

It looks like they ran it on VR5, but there is no longer anyone familiar with the Denford to confirm this.

Can anyone advise the best version(s) of software to use with this mill please and any indication of cost?
Thanks

Martin · Post by **Martin** » Thu 02 Sep , 2021 20:46 pm

Can you post of the a picture of the control card & the EPROM if it has one fitted.

GingerNinja54 · Post by **GingerNinja54** » Thu 02 Sep , 2021 21:08 pm

Will do

Collect the machine next Friday, so will be a few days…

(Excuse my utter ignorance… how do I identify the control card and what is the eprom plus how to identify it?!)

Steve · Post by **Steve** » Fri 03 Sep , 2021 11:40 am

If it was running on VR Milling 5 Then it must have been upgraded.

Licences of software are non transferable unless the terms of the licence agreemnet are adheared to and then there is a handleing fee.

The post below will explain how to identify the control card and EPROM.

https://www.denfordata.com/bb/viewtopic ... ers#p24265

Denford Software & Machines

Denford Software & Machines

1995 Triac Software (Advice needed!)

1995 Triac Software (Advice needed!)

Re: 1995 Triac Software (Advice needed!)

Re: 1995 Triac Software (Advice needed!)

Re: 1995 Triac Software (Advice needed!)