CNC Apprentice
CNC Apprentice
Posts: 40
Joined: Fri 06 Jul , 2012 9:35 am
Hardware/Software: Denford Orac
CNC Apprentice
CNC Apprentice
Orac steppers going spare

Post by lsteele »

Hello,

I have a couple of orac steppers that are left over from my refit. I'll give them (free) to a new home, but you have to come and get them from me. I'm in Acton, but could also take them with me to work in Reading. FYI I never ran these motors, so I can't say if they're working.

Let me know asap otherwise it's off to the tip with them!

Cheers,

Luke
Posts: 12
Joined: Fri 16 Feb , 2018 13:52 pm
Hardware/Software: Orac 1985 original
Did you get rid of these after or do you still have them?

Regards

Andy
CNC Apprentice
CNC Apprentice
Posts: 40
Joined: Fri 06 Jul , 2012 9:35 am
Hardware/Software: Denford Orac
CNC Apprentice
CNC Apprentice
Re: Orac steppers going spare

Post by lsteele »

Hi Andy,

I'm afraid they're gone. I was fed up with looking at them, and that was my 2nd attempt to get rid of them so I assumed they were of no use to anyone.

Cheers,

Luke
Post Reply

Information

Moderators

Martin, Steve, Mr Magoo