Good morning,,well here in Cape Town,South Africa anyway,
I'm hoping for a bit of information,,,I was fortunate enough to have found a senior horizontal milling machine,,,one like in the pic that hopefully I posted correctly,,,I will be looking for a owners manual of some sort on how to strip it down into smaller pieces for transport and at a later stage,,mastering the operation.I have had conflicting advice from a few people,so I'm looking for (and hopefully found) experts on the matter.
looking forward to learning from this forum,
Anthony
New to the forum,,and to milling on my own
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 1
- Joined: Wed 27 Sep , 2017 9:28 am
- Hardware/Software: Lap top + windows 10
New to the forum,,and to milling on my own
- Attachments
-
- main22.jpg (106.07 KiB) Viewed 13896 times