This document shows you how to set the permissions in Windows to allow files to be written to the common ProgramData directory.
Try this if you get error messages when trying to save configuration files, like saving the tooling configuration or offsets.
The Denford software stores data in a shared directory. All users must have read write access here for the software to run correctly.
This directory is a hidden directory so once the rights are granted the folder cannot be seen or accessed by users other than through the Denford software.
COMPUTER ACCESS Permissions for Denford Software
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
COMPUTER ACCESS Permissions for Denford Software
- Attachments
-
- WriteAccessOnDenfordProgramDataDirectory.pdf
- (345.54 KiB) Downloaded 1635 times