Hi!
I tried to power up Orac this morning but, screen only shows horizontal green bands containing half characters. Some of them I can hardly read.
This is very annoying though because the lines are flickering
Has someone ever encountered similar problem?
Could that be a monitor related symptom? In which case, replacing the screen with a good one solves this or is it a more complicated case originating at the computer which sends info to the video module.
If someone has an idea of what might have caused this monitor problem please help.
CNC Apprentice
Hi!
I tried to power up Orac this morning but, screen only shows horizontal green bands containing half characters. Some of them I can hardly read.
This is very annoying though because the lines are flickering
Has someone ever encountered similar problem?
Could that be a monitor related symptom? In which case, replacing the screen with a good one solves this or is it a more complicated case originating at the computer which sends info to the video module.
If someone has an idea of what might have caused this monitor problem please help.
I tried to power up Orac this morning but, screen only shows horizontal green bands containing half characters. Some of them I can hardly read.
This is very annoying though because the lines are flickering
Has someone ever encountered similar problem?
Could that be a monitor related symptom? In which case, replacing the screen with a good one solves this or is it a more complicated case originating at the computer which sends info to the video module.
If someone has an idea of what might have caused this monitor problem please help.
CNC Apprentice
...Found fault and restored.
Poor connection to video module.
Poor connection to video module.
Site Admin
Glad you sorted it..I'll move your other posts to the classifieds section (but leave shadow topics in this Orac section)