- unable-to-write-to-quickturn2d-fps.jpg (27.8 KiB) Viewed 13522 times
Normally only seen if quickturn2d.ini is deleted and only appears the 1st time the software runs after that.
Unable to write to quickturn2d.fps
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Unable to write to quickturn2d.fps
You may see this message on windows 7 or vista machines when closing down quickturn2d.
It is a bug which will be fixed in v1.13 or higher.
Normally only seen if quickturn2d.ini is deleted and only appears the 1st time the software runs after that.
It is a bug which will be fixed in v1.13 or higher.
Normally only seen if quickturn2d.ini is deleted and only appears the 1st time the software runs after that.