Hi, I have a Denford cyclone p Fanuc OT control system for spares or repair. After speaking to a few people I think some one with time on there hands can get this repaired. The saddle on the x axis is damaged and ball screw is broken, someone with the time and equipment may be able to fix this otherwise everything else is working fine. I have had many years useage from this machine but am now upgrading to something bigger. You can call me on 07917151608 if you need to know anything else.
Regards Neil
Denford Cyclone p spares or repair
Moderators: Martin, Steve, Mr Magoo
Denford Cyclone p spares or repair
Last edited by neilgixer on Fri 10 Jun , 2011 10:51 am, edited 2 times in total.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Denford Cyclone p spares or repair
Hi,
Might be worth posting a picture - It's easy enough to reduce and upload photos:
viewtopic.php?f=17&t=597
I think anyone looking would also want to know the control type and age - is it Fanuc 0TA, 0TC, 21i, DOS or Windows control ?
Might be worth posting a picture - It's easy enough to reduce and upload photos:
viewtopic.php?f=17&t=597
I think anyone looking would also want to know the control type and age - is it Fanuc 0TA, 0TC, 21i, DOS or Windows control ?