Hi,
Just got hold of another cyclone but this one is alot newer (think my other is like 86) this is a 1997 one with a denford Tutor and when i've put power to it, it just comes up with error 128, i've e-mail denford tech and showed them a pic in the back of the machine and they say i'm missing a STE motion card from the back, anyone got one or know where to get one??? i've got work waiting for it to run!!!!
Thanks in advance!
Regards
Kenny
TU150 U Won't Startup
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: TU150 U Won't Startup
here is the photo kenny sent in:
- Attachments
-
- IMAG0210-(Large).jpg (128.49 KiB) Viewed 3153 times