Hi,
Having found time to have a play again, I decided that I would try a little bit of Glass work using the Rotary attachment. unfortunatly I have not achieved anything.
1. I can not find a user manual (electronic or paper) for the Rotary attachment.
2. Having played and tried no marks are made on the glass, the head appears to be too far away from the glass surface
3. The travel of the head is very, very close to the Rotary and as such if it was closer to the glass it would hit the Rotary whilst on its travel.
What I need:
Advise on how to use the Rotary - User manual, Video, help
Many thanks
Nik (although Im using Richards account)
Rotary use
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Rotary use
I've added the user guide here:
viewtopic.php?f=5&t=3058
It has some instructions for the rotary fixture and the majority of it is still relevant for older models.
viewtopic.php?f=5&t=3058
It has some instructions for the rotary fixture and the majority of it is still relevant for older models.