I am interested in Finding out what the maximum Forces are in Newtons (N) that a ZeroCentre could tolerate are
in the X,Y,l (table directions) and expecially Z directions as I wish to use the machine for incremental forming.
Any suggestions on this or the motor/bearing specifications?
cheers,
Colin
Force Limits
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Force Limits
Sorry but I haven't seen any parts listings for the Zerocentre - only the Zeroturn.
I believe the Zerocentre carcass was imported from Taiwan and retrofitted by us.
I'll post the Brochure and anything else I find.
I believe the Zerocentre carcass was imported from Taiwan and retrofitted by us.
I'll post the Brochure and anything else I find.