Post Reply
willsauto
Posts: 11
Joined: Fri 30 Jun , 2006 4:21 am
Location: London , UK. + HK depot
Contact:
willsauto
Hello there:

anyone can help me to run my starturn4 at the lowest cost?

can i use lathcam fo my machine?


Kind regards

Will
Willsauto
User avatar
Denford Admin
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
User avatar
Denford Admin
Site Admin

Post by Denford Admin »

If you upgraded to VR Turning (see other reply) you would be able to use any Fanuc style CAM system to produce CNC code for this machine.
Post Reply

Return to “Software”

Information

Moderators

Martin, Steve, Mr Magoo