cnc controls for Denford lathe

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
NGTurning
Posts: 2
Joined: Mon 22 Mar , 2010 11:55 am

cnc controls for Denford lathe

Post by NGTurning » Mon 22 Mar , 2010 12:59 pm

sorry, i'm posting this again so i can get email feedback. I'm on the market for a cnc lathe. I'm looking at a Denford but it is without the controls. Does anyone know if you can buy the controls ? If so how much ?
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: cnc controls for Denford lathe

Post by Denford Admin » Tue 23 Mar , 2010 10:44 am

What do you mean by controls ?
The tutor keyboard ? Push buttons on the machine ? A fanuc control system ? A baldor motion control card ?
Top
Post Reply

Return to “Cyclone”