Page 1 of 1
Micromill 2000
Posted: Fri 26 Sep , 2008 21:05 pm
by Benny
Customer writes in...
Wires to E-Stop switch were disconnected by student. I reconnected the 2 orange wires to the E-Stop Switch but now machine will not power--- HELP!
Micromill 2000 NS
Posted: Fri 26 Sep , 2008 21:06 pm
by Benny
Customer checked fuses and determined that Fuse F2 was blown. He replaced and machine is up and running.
machine set up
Posted: Wed 03 Dec , 2008 20:51 pm
by Bill Walter
How do I get my mill to communicate with the computer? I have run Mill designer and tested the part in the virtual machine mode. The computer is not interfacing with the mill.
Posted: Thu 04 Dec , 2008 10:55 am
by Denford Admin
Hi Bill - is this your machine that was sabotaged by the students ?
If its is, then its possible the RS232 comms has been blown as well as the fuse - this could be on the machine control card, the PC RS232 port or even both