Micromill Comm Error

boots · Thu 15 Nov , 2007 16:27 pm

We have a Micromill with a communications error.

There is a “0” on the Denstep LED Display, according to the manual it is a “No comms board address fault”.

How do I correct this and get the machine up and running??????

Thanks for any help.

Tue 27 Nov , 2007 17:14 pm

is this a red or green seven segment display ?

I can't find 0 in the old denstep manual, but i can find small o (control in Offset mode)

boots · Tue 27 Nov , 2007 17:39 pm

The machine is up and running now.
The relays were unplugged and re-intstalled and the fuse on the control card was removed and reinstalled. Possible loose connection.

Red LED Display.

Micromill 2000 Machine Manual
Page 8.4 - Electronics
"The DenStep Control Board"
"LED Status and Fault Display"
Display "0" Meaning "No comms board address fault."

Information