Page 2 of 2
Re: Cyclone turret alignment issue
Posted: Tue 14 Dec , 2010 11:32 am
by Martin
Is it the centre line or centre height that's out?
Re: Cyclone turret alignment issue
Posted: Tue 14 Dec , 2010 13:36 pm
by H12UAJ
centre line
Re: Cyclone turret alignment issue
Posted: Tue 14 Dec , 2010 13:53 pm
by Martin
What model of Fanuc control is fitted?
Re: Cyclone turret alignment issue
Posted: Tue 14 Dec , 2010 17:22 pm
by H12UAJ
GE Fanuc Series 21i-T
Re: Cyclone turret alignment issue
Posted: Tue 14 Dec , 2010 17:40 pm
by Martin
Do you know if it has datum switches fitted?
You need to reset the X axis home position which is a bit tricky.
There is a procedure sheet that tells you how to set it. I should be able to add a coppy next time I am in the office. (Next Monday)
Re: Cyclone turret alignment issue
Posted: Tue 21 Dec , 2010 17:19 pm
by Martin
Reference procedure for a Fanuc 21I without reference switches.