Denford Software & Machines

Here is my bit done - all the SP and CH series, plus the SK series from pages 1-8 and 10-14 (courtesy of Triac Whizz).
I've also added a sheet to start identifying the drawing series codes to machines - e.g. BVS= 280VS lathe, SL= 280 Synchro lathe, TR=Triac, etc.

Andy

Hi

after a long delay... ho hum, well I am rather busy at present...

Here's the latest version with Andy B's bit added in, (good work Andy) up to page 26 but some are missing cos I didn't have the print outs with me when I was inputting - I'll rectify that as time allows.