Customer writes:
Mirac PC - circa 1993
Machine Serial Number: E0 4367
Electronics Serial Number: 93281036/017237
Still using DOS software
The orange gear box that indexes the tool changer has locked up. I would like a quote on a replacement or where I could send it to get it fixed. All I actually need is the gear set that is inside it. Can you help?
CNC Guru
The Machine records shows the Toolpost as a Denford Designed DMT 8ST.
The grease used at the time tended to harden with age and lock the gears up. We tend to strip down and clean out the old grease and replace with a Kluber ISOFLEX NBU 15 grease. I will try and get some photo's of the stripped down gear box and a product code for the grease. If you can get some photos of the gears that need replacing I will check to see if they are available. Does the Tool post look like this ?
The grease used at the time tended to harden with age and lock the gears up. We tend to strip down and clean out the old grease and replace with a Kluber ISOFLEX NBU 15 grease. I will try and get some photo's of the stripped down gear box and a product code for the grease. If you can get some photos of the gears that need replacing I will check to see if they are available. Does the Tool post look like this ?
Attachments:
- DM8 Tool Post 12.JPG (81.21 KiB) Viewed 9038 times
- DM8 Tool Post 8.JPG (115.36 KiB) Viewed 9039 times
- DM8 Tool Post 7.JPG (108.36 KiB) Viewed 9043 times
- tp126.pdf
- (157.42 KiB) Downloaded 1251 times
