Hello does anyone know what the spindle bearing model is on the Denford Starmill, I know it is made by THK but without dissmantling I am not sure of the part number?
TIA
SRG
CNC Apprentice
CNC Apprentice
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
These drawings may help...
The Novamill which is the successor to the Starmill uses the same bearing, and our notes say to use SKF 7208B only
The Novamill which is the successor to the Starmill uses the same bearing, and our notes say to use SKF 7208B only
Attachments:
- starmill-spindle-1of3.jpg (61.94 KiB) Viewed 8261 times
- starmill-spindle-2of3.jpg (31.52 KiB) Viewed 8262 times
- starmill-spindle-3of3.jpg (29.48 KiB) Viewed 8261 times
CNC Apprentice
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
)