Micromill 2000 - RS232 Error

Benny · Tue 16 Oct , 2007 13:05 pm

Micromill 2000 NS

On connecting to machine, always get an RS232 error, but Lindy RS232 is connected. The green LED display shows a “2”. 1 LED lit on power card. I have replaced the 5 fuses and all appear to be ok. I have reloaded software VR CNC Milling 2.31 with no luck.

Benny · Tue 16 Oct , 2007 13:06 pm

Customer checked fuse holder FS4, it was loose. Customer tightened up the fuse holder to clamp on the fuse tighter. Machine is running perfectly.

Steve · Tue 16 Oct , 2007 15:24 pm

Always disconnect the power and leave the machine a few minutes before doing this.

If you then take the fuse out completely it is easy to nip the prongs together before refitting the fuse.

Information