Denford software on RM CC3 Networks
Moderators: Martin, Steve, Mr Magoo
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
Denford software on RM CC3 Networks
I need to know the procedure for getting Denford software on RM CC3 Networks ?
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
I think this may be of help, Hopefully 
Denford's newer software has and MSI for installation, it also requires a registration code (SecKey.tff, make a back up because replacements are chargeable) usually supplied on a 3-1\2" floppy disc registered to the school or college.
1. Copy all the files / directories off your Denford software installation disc to a hard disc.
2. Copy the registration code (SecKey.tff) off the 3-1\2" floppy disc to the following diectory
\Program files\denford\Denford product software name e.g. QuickCAMPRO
I think this will work, perhaps Admin will comment further on the Technical side
Denford's newer software has and MSI for installation, it also requires a registration code (SecKey.tff, make a back up because replacements are chargeable) usually supplied on a 3-1\2" floppy disc registered to the school or college.
1. Copy all the files / directories off your Denford software installation disc to a hard disc.
2. Copy the registration code (SecKey.tff) off the 3-1\2" floppy disc to the following diectory
\Program files\denford\Denford product software name e.g. QuickCAMPRO
I think this will work, perhaps Admin will comment further on the Technical side