Alphacam post for Denford Cyclone

Bolan41 · Post by **Bolan41** » Mon 29 Aug , 2022 19:29 pm

Hi all does anyone know if there is a Alphacam post for for a Cyclone lathe. I have just purchased this machine so all a bit new to me mostly ese cnc routers. Thanks

rasp · Post by **rasp** » Wed 31 Aug , 2022 1:35 am

The Fanuc 15,18 or 21 post should work fine.

Bolan41 · Post by **Bolan41** » Sat 03 Sep , 2022 6:36 am

Hi thanks for the reply, what about the 6Tpost would that work?

rasp · Post by **rasp** » Sun 18 Sep , 2022 17:34 pm

I will work as long as you do not use the canned cycles in Alphacam, The 6T post is single line canned cycles, the 0i,15 18i and 21i are all 2 line canned cycles unless you have the F15 option installed in the control.

Information