Having purchased a 1995 Triac VMC, I need to source Control, CAM and perhaps even CAD software. (Unfortunately the college from which I purchased the VMC couldn’t provide this).
It looks like they ran it on VR5, but there is no longer anyone familiar with the Denford to confirm this.
Can anyone advise the best version(s) of software to use with this mill please and any indication of cost?
Thanks
Regards,
GN54
Toolmaker & milling specialist by day...
...bumbling idiot & 'Home-Engineer by weekend & night!
Responses, support and advice is appreciated
Triac VMC (1995) With USB upgrade & VR Milling 5
GN54
Toolmaker & milling specialist by day...
...bumbling idiot & 'Home-Engineer by weekend & night!
Responses, support and advice is appreciated
Triac VMC (1995) With USB upgrade & VR Milling 5
CNC Guru
Can you post of the a picture of the control card & the EPROM if it has one fitted.
Will do 
Collect the machine next Friday, so will be a few days…
(Excuse my utter ignorance… how do I identify the control card and what is the eprom plus how to identify it?!)
Collect the machine next Friday, so will be a few days…
(Excuse my utter ignorance… how do I identify the control card and what is the eprom plus how to identify it?!)
Regards,
GN54
Toolmaker & milling specialist by day...
...bumbling idiot & 'Home-Engineer by weekend & night!
Responses, support and advice is appreciated
Triac VMC (1995) With USB upgrade & VR Milling 5
GN54
Toolmaker & milling specialist by day...
...bumbling idiot & 'Home-Engineer by weekend & night!
Responses, support and advice is appreciated
Triac VMC (1995) With USB upgrade & VR Milling 5
CNC Guru
If it was running on VR Milling 5 Then it must have been upgraded.
Licences of software are non transferable unless the terms of the licence agreemnet are adheared to and then there is a handleing fee.
The post below will explain how to identify the control card and EPROM.
https://www.denfordata.com/bb/viewtopic ... ers#p24265
Licences of software are non transferable unless the terms of the licence agreemnet are adheared to and then there is a handleing fee.
The post below will explain how to identify the control card and EPROM.
https://www.denfordata.com/bb/viewtopic ... ers#p24265