triac pnc ballscrew

Large519 · Post by **Large519** » Tue 02 Dec , 2014 11:03 am

I'm looking at replacing the x axis ballscrew does anyone know of direct replacement part.

andy_con · Post by **andy_con** » Tue 02 Dec , 2014 13:58 pm

whats the issue, i just had mine reballed

Large519 · Post by **Large519** » Tue 02 Dec , 2014 17:03 pm

Oh, I didn't realise you could get them reballed,....

I assume that is alot cheaper than a new one.
But that is the issue, quite a while ago I stripped the machine down and lost a few ball bearings from the x axis ball nut, recently it has been, almost like snapping in the axis, at certain points, and wondered whether the ball screw was now playing up due to the loss of bearings, I haven't got round to stripping it down yet, but that is my plan over the Xmas hols. Where did you get them re balled?

andy_con · Post by **andy_con** » Tue 02 Dec , 2014 23:01 pm

https://www.motionandbearing.co.uk

Large519 · Post by **Large519** » Wed 03 Dec , 2014 10:19 am

Thats great, thank you.

Information