UP! 3D Printer enclosure

[j.zarzoso]

Hi all,

Could anyone please suggest an enclosure to keep the temperature level without overheating the electronics?

Thanks!

Jaime

[Denford Admin]

There is a nice design here:
https://www.pp3dp.com/forum/viewtopic.ph ... ure#p13959
and another here:
https://www.thingiverse.com/thing:34032

You're right to worry about the electronics - I'd just make sure there is plenty of airflow through the bottom half of the UP!

[j.zarzoso]

Thanks for the info, much appreciated!

I could also find this option in plexiglass: https://www.thingiverse.com/thing:43859

Thanks again!