Viceroy TDS in sad condition

If you've had enough of reading, then look at these pictures of the "good" old days. Machine brochures, magazines etc..

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
dazz
CNC Expert
CNC Expert
Posts: 246
Joined: Sat 19 Aug , 2006 11:31 am
Hardware/Software: Viceroy TDS 1/1GB lathe, Imperial, stripped down and rebuilt.
Viceroy Taper/Tracer attachment, Shop made cross slide tracer attachment, VSD.
Location: New Zealand

Viceroy TDS in sad condition

Post by dazz » Sun 24 Feb , 2008 9:43 am

This is an old Viceroy Lathe in very sad condition. Seen on a New Zealand on-line auction Feb 2008.

It's clearly had a hard life with many parts missing including the tailstock and the half-nuts.

It's a fully metric so it is probably a lot younger than mine, but the years have not been kind to this example.

This is the only other Viceroy I have seen in New Zealand. I am glad I don't own it.
Attachments
61205520_full.jpg
61205520_full.jpg (40.62 KiB) Viewed 26003 times
61055998_full.jpg
61055998_full.jpg (39.52 KiB) Viewed 26035 times
61056040_full.jpg
61056040_full.jpg (48.45 KiB) Viewed 26035 times
61056021_full.jpg
61056021_full.jpg (40.87 KiB) Viewed 26035 times
Last edited by dazz on Wed 27 Feb , 2008 10:25 am, edited 1 time in total.
Regards

Dazz
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 26 Feb , 2008 10:45 am

Is that a pile of swarf in the back - or teeth :?
Top
Multispool
Posts: 22
Joined: Mon 04 Aug , 2008 11:28 am

Post by Multispool » Sun 14 Sep , 2008 14:06 pm

Just looking at those pictures,

Where is the drive lever Engage/disengage?
Early Denford metric manual Mill
Retrofitted Triac
Easiturn-3
Top
User avatar
dazz
CNC Expert
CNC Expert
Posts: 246
Joined: Sat 19 Aug , 2006 11:31 am
Hardware/Software: Viceroy TDS 1/1GB lathe, Imperial, stripped down and rebuilt.
Viceroy Taper/Tracer attachment, Shop made cross slide tracer attachment, VSD.
Location: New Zealand

Re: Viceroy TDS in sad condition

Post by dazz » Mon 11 Feb , 2013 9:47 am

Hello

Another old Viceroy on auction in New Zealand.
It looks like it is fitted with a very basic gear box.
It probably has a set of change wheels included.

Dazz
Attachments
Viceroy lathe.jpg
Identified as a model TDS1/1g.c.s.
Viceroy lathe.jpg (84.5 KiB) Viewed 23614 times
Regards

Dazz
Top
Post Reply

Return to “Vintage Pictures”