Help with Denford micromill wiring

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
LoganWPatch
Posts: 1
Joined: Sat 26 Jan , 2013 21:44 pm
Hardware/Software: Denford micromill 1997
mach s/n sp40502b
elect s/n oc00127942

Help with Denford micromill wiring

Post by LoganWPatch » Sun 27 Jan , 2013 0:21 am

I just got this mill that was made in 1997. I would like to rewire it but I can not find the right wiring diagram for the board and the transformer
Attachments
board and power.jpg
board and power.jpg (1.14 MiB) Viewed 4954 times
back.jpg
back.jpg (1.03 MiB) Viewed 4954 times
micromill.jpg
micromill.jpg (992.57 KiB) Viewed 4954 times
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: Help with Denford micromill wiring

Post by Denford Admin » Wed 30 Jan , 2013 10:17 am

I've found some more drawings and posted them here:
viewtopic.php?f=36&t=2929

But can't help feeling that 1997 is slightly before the information we have here in the UK and may well have been kept in the USA office
Top
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1451
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Help with Denford micromill wiring

Post by Steve » Thu 31 Jan , 2013 15:25 pm

I think this is what you are after:

Its a bit basic but should cover most things.
Attachments
SMARTSTEP SCHEMATIC.pdf
(114.64 KiB) Downloaded 660 times
Top
Post Reply

Return to “Micromill / Microturn”