Microturn Spindle Encoder

[762x51]

While I'd love to have an original Denford encoder, cost of a new one for my "hobby" machine is simply out of reach and fitting a "hobby" priced encoder is my only option.
After a load of reading on the board I think I have enough information to get started.

Do I have the following correct?

Spindle motor to encoder drive: 1:1 belt
5VDC supply
Counts: 2000 PPR (Uses A output - A/ unused) DenStep reads both rising and falling pulse edge thus Encoder Count = 4000 in INI file.
Index (Z): 1 PPR
Line Driver output

After fitting an encoder I should use MicroTurn2000NS.ini configuration file.

I have my fingers crossed that I have this right -

[Denford Admin]

Yes that all looks correct to me.
If the line count is a problem you can always alter the mint (.mnt) file to suit

[762x51]

Yes that all looks correct to me.
If the line count is a problem you can always alter the mint (.mnt) file to suit

Thank you very much for confirming the encoder data and also the note regarding the mint (.mnt) file.

Regards,
Orin