Baldor eurocard schematic and 96 way pinout
Moderators: Martin, Steve, Mr Magoo
- Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Baldor eurocard schematic and 96 way pinout
Baldor eurocard schematic and 96 way pinout:
- Attachments
-
- baldor-eurocard-schematic-and-pinout.pdf
- (633.11 KiB) Downloaded 3618 times
Re: Baldor eurocard schematic and 96 way pinout
Thanks but the a/c/b table and page 5 onlly discusses stepper 0 to 2 does that mean there is no channel number 3 for a 4th stepper axis?
Re: Baldor eurocard schematic and 96 way pinout
Or am i looking at getting using the option IO lines?
Cheers
Barry
Cheers
Barry
- Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Baldor eurocard schematic and 96 way pinout
Yep you're right sorry - we must have used that sandwich board just to tap off the X,Y and Z step+direction in order to use bigger stepper drives (before Baldor fitted an IDC connector with all 4 axes on the top board for us)