Laser is not penetrating the material as good as it used to

bradders · Post by **bradders** » Thu 06 Jul , 2006 13:18 pm

The Laser beam is not penetrating the material as good as it used to ?

bradders · Post by **bradders** » Thu 06 Jul , 2006 13:21 pm

Read the Laser manual for mirror and lens cleaning procedures

1. Ensure the Mirrors are clean
2. Ensure the Lens is clean
3. Ensure the Window on the Laser cartridge is clean
4. Remove any deposits from the nozzle of the air assist cone

Martin · Post by **Martin** » Thu 05 Oct , 2006 19:12 pm

Yon may also need to check the focus height. This can be done by using the manual focus tool as described in the VersaLaser manual.

Martin · Post by **Martin** » Fri 06 Oct , 2006 1:08 am

Focusing the laser beam

Martin · Post by **Martin** » Fri 05 Jan , 2007 16:25 pm

The Versalaser CPU holds all the positions & can be reset with the guide attached.
The flat metalic bed needs to be used when setting the heights.

Denford Software & Machines

Denford Software & Machines

Laser is not penetrating the material as good as it used to

Laser is not penetrating the material as good as it used to

Auto-Z & Rotary Calibration