Hi, I have a US market micromill 2000 serial 60182 DOM 2002. I have vrmill 1.75 and the board is a denstep will this software work with this board? I have a straight through serial cable but not the one that came with the machine.
Site Admin
Not sure what v1.75 is - are you sure that isn't the DOS software ?
vrmilling will be v2.xx or v5.xx
This guide should help you decide what you have got:
viewtopic.php?f=4&t=116
A pin-pin serial cable should be the right one for a US machine.
vrmilling will be v2.xx or v5.xx
This guide should help you decide what you have got:
viewtopic.php?f=4&t=116
A pin-pin serial cable should be the right one for a US machine.