Model:TDS/C/R/CNC - spindle problems

All info relating to Viceroy machines - Lathes, sharpedge, drills etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Model:TDS/C/R/CNC - spindle problems

Post by bradders » Tue 08 Feb , 2011 6:34 am

Customer writes ......

Hi

New to this site.

We have a problem with the speed contol on our lathe.

Model:TDS/C/R/CNC (Feb 1985)

When in manual mode, the spindle will start, however when we try to vary the speed, via the +ve / -ve keys on the spindle speed section of the keyboard, there is no response in either direction.

At present the spindle speed is varying (self-fluctuating) between 100RPM & 120RPM.

Does anybody have a solution?

Thank You
Martin
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: Model:TDS/C/R/CNC - spindle problems

Post by Denford Admin » Tue 08 Feb , 2011 10:16 am

Haven't you asked this already ?
viewtopic.php?f=50&t=3131
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Re: Model:TDS/C/R/CNC - spindle problems

Post by bradders » Tue 08 Feb , 2011 11:16 am

I got it via a PM, and just posted it, did not search the forum
Top
Post Reply

Return to “Viceroy”