Page 1 of 1
Quickcam turning?
Posted: Wed 18 Apr , 2007 13:10 pm
by paul
I have just noticed quickcam turning installed onto one of the school computers connected to my milling machine, Its fully working and registered but I dont seem to have the disk and cant find it in the download section, is this a obsolete program now, it looks like a better option to lathe cam designer.
Cheers
Paul
Posted: Wed 18 Apr , 2007 14:26 pm
by Denford Admin
QuickCAM Turning was shelved due to other commitments, and the even better version coming along shortly.
If it works for you then great, but I'm afraid it will not be supported in the future.
I'll see if I can find the last known working version, and upload it
Posted: Wed 18 Apr , 2007 14:44 pm
by Denford Admin
Posted: Wed 18 Apr , 2007 18:24 pm
by paul
Thanks, it will be interesting to see the new development as lathecam designer is a little limited.
Cheers
Paul