Denford Software & Machines

We have an old Denford Micromill,serial #sp50901e, build date 8/99, control card #ds00217223.
What do I need to download from your DOS software to get this up and running again and is DOS Millcam available also?
Thank You

Have a look here:

viewtopic.php?t=856

Maybe its FanucSMD ?

Millcam was developed for windows (as far as I know), but there may have been a previous DOS equivalent - what about AutoCAM ? - I have seen that in the vintage section.
Its probably not worth pursuing a DOS CAM system - MillCAM will run on windows 95, and the DOS machine software will probably run quite happily from the same.