Page 1 of 1
DOS software identification required
Posted: Thu 29 Mar , 2007 7:43 am
by bradders
Can anyone tell me whats the difference in function of these Milling and Lathe DOS software versions?
FanucSLD
FanucSMD
FanucL
FanucLD
FanucM
FanucMD
Posted: Thu 29 Mar , 2007 10:59 am
by Mr Magoo
I can't remember but....
There were some different pieces of sotfware all with the same EXE name (crap idea - not mine). So a piece of software called FANUCMD.EXE was for Desk Top Tutor, and a completely different piece of software, also called FANUCMD.EXE controlled a TRIAC. Bloody nightmare
- FanucSLD
Starturn with DTT and GSM controller (Not Baldor as I previously stated!)
Might also have been for Microturn
- FanucSMD
Starmill with DTT and Baldor controller (I think)
Might also have been for Micromill (or was the FANUCMS)
- FanucL
Fanuc Lathe Offline - not for machine control
- FanucLD
Fanuc Lathe Desk Top Tutor (not for machine control)
(Might have been a version that also controlled a mahcine too?)
- FanucM
Fanuc Milling Offline - not for machines
- FanucMD
Fanuc Milling Desk Top Tutor
Triac PC
Triac VMC
Posted: Thu 29 Mar , 2007 11:37 am
by bradders
Cheers for that James