Can anyone tell me whats the difference in function of these Milling and Lathe DOS software versions?
FanucSLD
FanucSMD
FanucL
FanucLD
FanucM
FanucMD
DOS software identification required
Moderators: Martin, Steve, Mr Magoo
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
DOS software identification required
Last edited by bradders on Fri 11 May , 2007 7:52 am, edited 1 time in total.
I can't remember but....
There were some different pieces of sotfware all with the same EXE name (crap idea - not mine). So a piece of software called FANUCMD.EXE was for Desk Top Tutor, and a completely different piece of software, also called FANUCMD.EXE controlled a TRIAC. Bloody nightmare
There were some different pieces of sotfware all with the same EXE name (crap idea - not mine). So a piece of software called FANUCMD.EXE was for Desk Top Tutor, and a completely different piece of software, also called FANUCMD.EXE controlled a TRIAC. Bloody nightmare
- FanucSLD
Starturn with DTT and GSM controller (Not Baldor as I previously stated!)
Might also have been for Microturn - FanucSMD
Starmill with DTT and Baldor controller (I think)
Might also have been for Micromill (or was the FANUCMS) - FanucL
Fanuc Lathe Offline - not for machine control - FanucLD
Fanuc Lathe Desk Top Tutor (not for machine control)
(Might have been a version that also controlled a mahcine too?) - FanucM
Fanuc Milling Offline - not for machines - FanucMD
Fanuc Milling Desk Top Tutor
Triac PC
Triac VMC
Last edited by Mr Magoo on Tue 14 Aug , 2007 10:03 am, edited 1 time in total.