Following the right RS232 cable config and software operation. On using the CNC machine protocal to drive the machine I get this message.
A connection to your starmill could not be made. Press remote on ( that was done) Check power (OK) and RS232 I think it is ok though breakout box
Can any body help?
Starmill software
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
I'm afraid all I can suggest is looking through the list of usual suspects to do with RS232 errors / no communication:
viewtopic.php?t=544
viewtopic.php?t=544