Page 1 of 1

Right software/post prosessor fpr Triac Fanuc 0m-b

Posted: Mon 13 Jun , 2022 22:13 pm
by bjornove
Hi

i need a little help with determin which pc software for program transfer and possible dripfeeding.
can't seem to find the correct one in denford software libary.

have tried FANUCM and TRIAC dos software for transfer the files.
the diffrent programs handles G-codes and -Mcodes diffrentely. soooo i dont think i have found the right one.

when using the generic Fanuc postprosessor in Fusion 360 i get codes the Mill wouldnt accept.
is there any guidlines for what it accepts??
or any software i can use that checks my code??

software version on the mill is 0415-09

thank you in advance.