Denford Software & Machines

Installed a new PC to use our VRTurning software. It asked for dongle. I ran the registratrion floppy that came with the CD. Still asked for dongle. I followed instructions on the #1012 pdf sheet...
STILL ASKS FOR DONGLE! Any suggestions?
The VRMilling software works fine after #1012 instructions but obviously not with the VRTurning.
HELP!

Thanks all.
-Bob Cooper
Lab & Facilities Mngr.
Morehead State University
Morehead Kentucky 40351

Hi Bob,

Sounds like it may be easier to coppy the licence disc manually.


You need to open the text file on the licence disc then coppy the text & paste it into the VRTurning.ini file.

There is also a slight chance that the disk has been created with the wrong data, or is corrupt.

Contact your supplier if you really can't get anywhere

- Admin on holiday