Denford Software & Machines

Can I grab some legacy software from here https://website.denford.ltd.uk/support/9 ... s-software
Use the Flashes.txt to unlock the software and use that to run my Microturn lathe?

I can dig up a WIN98 disk and setup an older computer to run the software.
IF all the above is correct do I need a certain cable to hook up from my com port to the 25 pin port on the lathe?

I have another thread where I ask about using Mach3 and a driver board but if I can get it up and running using the original software I'll go that route.
Of course I'm not sure of my options, I just bought the lathe.

What is the color of the seven segment LED? If it's red what version is the Eprom?

2.0B/10/S/B/B19/JD5
The seven segement display is red.

I think that is a VR Eprom so none of the legacy Dos software would connect.

We do sell single user licences of the VRTurning software.

Where are you located?

Texas , US

You would need to contact your local agent for a price.