HEIDENHAIN - Error Messages
Posted: Mon 06 Jun , 2011 14:52 pm
Customer asks.......
What is a "PLC Error 00"?
What is a "PLC Error 00"?
ERROR LIST FOR SENIOR3C/QUATRO WITH A TNC355 CONTROL
****************************************************
Error message list for file 'QUATRO-E.PC'
00 - "AXIS LUBRICATION LEVEL LOW"
01 - "M06 TOOL CHANGE PROGRAMMED"
02 - "SPINDLE DRIVE FAULT"
03 - "X AXIS DRIVE FAULT"
04 - "Y AXIS DRIVE FAULT"
05 - "Z AXIS DRIVE FAULT"
06 - "IV AXIS DRIVE FAULT"
07 - "X AXIS MOTOR OVERHEAT"
08 - "Y AXIS MOTOR OVERHEAT"
09 - "Z AXIS MOTOR OVERHEAT"
10 - "IV AXIS MOTOR OVERHEAT"
11 - "LOW AIR PRESSURE !"
12 - "SELECTED MODE NOT AVAILABLE"
13 - "SELECT CNC MODE BEFORE REFERENCING"
14 - "GUARD OPEN !"
15 - "VICE INTERLOCK"
There are also the following USER PARAMETERS:
00 - "ISO PROGRAMMING"
01 - "V24 DATA FORMAT"
02 - "DNC MODE"
03 - "TOOL FILE"